Canon EOS 1N RS Instrukcja Użytkownika

C 4/i-C‘ ¿ /'anonEOS-1 SI EOS-1 SIRS

NomenclatureX ContactsAccessory ShoeShooting Mode Selector (page 17)AF Mode Selector page 32)Metering Mode Selector / Flash Exposure Compensation Bu

NomenclatureShooting Modes —Manual Exposure: M Shutter-priority AE; Tv BulbExposure; b uL b Program AE: P Aperture-priority AE: Av * Depth-of-Field A

NomenclatureFocusing Points/Spot Metering Position IndicatorsFine Spot Metering AreaLaser-matte Screen Ec-CII - Manual Exposure IndicatorAE Lock /

f Shooting Preparations and Basic OperationThis section explains the preparations necessary to set up the camera before use, as well as the basic ope

1. Loading the BatteryThis camera operates on a 6-volt, 2CR5 lithium battery, housed in the grip.• Refer to page 93 for additional i

“I Set the main switch to “A”.2 Open the palm door and press the battery check button.2. Checking the Battery LevelbeI__1 1II FIZZ3 The battery

3. Operating the Main SwitchThe main switch has three settings, as described below;11 : The power is off and the camera does not operate.

4. Setting and Adjusting Basic FunctionsThis camera’s shooting mode, AF mode and metering mode are set and changed as follows;Set the main sw

5. Lens Attachmentj Remove the lens' rear dust cap and the camera's body cap by turning them counterclockwise.2 Align the red

6. Dioptric AdjustmentThe viewfinder has a built-in dioptric adjustment mechanism that lets you adjust the eyesight correction to achieve a sha

Welcome to the World of the EOS-1 N, The Flagship Camera of the EOS SeriesThank you for selecting a Canon EOS camera.Thousands of professional photogr

7. Shutter Button Operation and AutofocusThe shutter button has a two step construction. Press halfway (to the first step) to activate focusing and me

Shutter Button Operation and Autofocus2. Pressing CompletelyThis releases the shutter and takes the picture, then advances the film. The LCD panel’s f

8. Film LoadingWhen DX film is loaded, the film speedis set automatically according to theDX code on the film cartridge.• The automatic film speed

j Set the main switch to “A”.Film LoadingOpen the back cover by using your thumb to press the back cover lock release button while slid

Film LoadingWRONGFilm transport (wind/rewind) Film-load check symbolOAfter checking that the film tip is aligned with the orange mark and t

Film Loading# Removing FilmThe film automatically rewinds at the end of the roll.r\ • /-(§1-___> V“j When rewinding starts, the film rewind i

10. Program AE mode [P]In Program AE mode the camera automatically sets the shutter speed and aperture value according to the subject bright

Program AE mode [P][Exposure Warnings]___________________________________If a shutter speed ot 30” and the maximum aperture value blink in

Il Selecting the AF and Metering Modesnu □□ □This camera’s wide-zone autofocus system lets you freely select from five focusing points, allowing yo

1. Selecting the Five Focusing PointsThis camera incorporates a high-precision AF sensor called Multi-BASIS (Multi Base-Stored Image Sensor

The EOS-1 N family consists of the following three models in addition to the standard model:• EOS-1 N DP: This model combines the BP-E1* AA-size bat

Selecting the Five Focusing Points• Turning the main dial selects the focusing points in the following order: automatic focusing point selection (all

Camera Care and Precautions...61. Handling, Cleaning and Storage...62. Liquid Crystal Display information...71 Shooting Preparations and Basic Op

3. Blinking “ be ” Display...75. Camera Operation with a Low4. Battery Information...8Battery...8N

Camera Care and Precautions1. Handling, Cleaning and Storage• This camera is a high-precision instrument. Be careful not to drop it or subject it to

Camera Care and Precautions• A minute amount of battery power is used for the display even when the main switch is set to B . Thi

Camera Care and Precautions4. Battery informationThis camera requires battery power for operation. Always check the battery at the followi

Nomenclature• Page numbers of sections related to each component are indicated in parentheses.