
Network Setting
Note
• The subnet mask and default gateway are set to “0.0.0.0.” Use RemoteUI to change the subnet mask
and default gateway to match your network settings.
For details on RemoteUI , see “Using RemoteUI”. (→P .569)
Conguring TCP/IPv6 Network Settings
When printing in a TCP/IPv6 network, you must congure the TCP/IPv6 settings on the Control Panel .
Follow the steps below to congure the TCP/IPv6 network settings.
1. On the T ab Selection screen of the Control Panel , press ◄ or ► to select the Settings/Adj.
tab ( ).
Note
• If the T ab Selection screen is not displayed, press the Menu button.
2. Press the OK button.
The Set./Adj. Menu is displayed.
3. Press ▲ or ▼ to select Interface Setup , and then press the OK button.
4. Press ▲ or ▼ to select TCP/IP , and then press the OK button.
5. Press ▲ or ▼ to select IPv6 , and then press the OK button.
6. Press ▲ or ▼ to select IPv6 Support , and then press the OK button.
7. Press ▲ or ▼ to select On , and then press the OK button.
Important
• Once you set IPv6 Support to On , the IPv6 StlessAddrs setting takes ef fect.
• Y ou can also congure IPv6 StlessAddrs and DHCPv6 from the printer Control Panel .
568 Network Setting
Komentarze do niniejszej Instrukcji