
Network Setting
Conguring the IP Address Using the Printer Control
Panel
This topic describes how to congure the printer ’ s IP address on the Control Panel .
1. On the T ab Selection screen of the Control Panel , press ◄ or ► to select the Settings/Adj.
tab ( ).
Note
• If the T ab Selection screen is not displayed, press the Menu button.
2. Press the OK button.
The Set./Adj. Menu is displayed.
3. Press ▲ or ▼ to select Interface Setup , and then press the OK button.
4. Press ▲ or ▼ to select TCP/IP , and then press the OK button.
5. Press ▲ or ▼ to select IPv4 , and then press the OK button.
6. Press ▲ or ▼ to select IPv4 Settings , and then press the OK button.
7. Press ▲ or ▼ to select IP Address , and then press the OK button.
8. After you press ◄ or ► to select the input eld, numerical input is possible.
9. Press the ▲ or ▼ button to enter the value.
Note
• Pressing the ▲ button increases the number by 1. The maximum value is “9,” after which “0” is
displayed.
• Pressing the ▼ button decreases the number by 1. The minimum value is “0,” after which “9” is
displayed.
• Hold down ▲ or ▼ to increase or decrease the value continuously .
• Make sure the IP address you enter for the printer is not the same as any computer IP address
in your network.
10. Repeat steps 8 and 9 to complete the settings, and then press the OK button.
1 1. Press the Menu button.
If you have changed the settings, a conrmation message is displayed. Press ▲ or ▼ to select
Y es , and then press the OK button.
Network Setting 565
Komentarze do niniejszej Instrukcji